Objectives of the course
The participants can apply the touch probe cycles in manual and automatic mode and log the measured values
Target group
Programmers and operators of CNC milling machines, CNC trainers
Requirements
Completion of the Basic Training, or the equivalent knowledge of programming and operating the TNC control
Course contents
Fundamentals
- Setup of touch probes
- Centering the touch probe
- Editing the touch probe table
- Editing the preset table
Touch probe cycles in the manual and electronic handwheel modes
- Calibrating a touch probe
- Compensating workpiece misalignment
- Workpiece presetting
Touch probe cycles for automatic workpiece inspection
- Automatically measuring workpiece misalignment
- Automatic presetting
- Automatically recording measurement results
- Automatically measuring workpieces
- Logging tool dimensions
- Creating freely definable table
Align the plane
- Manual operation
- Define Cycle 431 measure plane
KinematicsOpt
- Testing and optimizing the kinematics
Please note that this training class is subject to cancellation if the minimum participant count is not met by two weeks before the scheduled start date. All registered participants will be notified in the event of a cancellation and offered the opportunity to reschedule.
After submitting your registration, someone will be in contact with you regarding payment. Registration is considered confirmed only after your payment has been received.
